Misplugging is a kind of wrong behavior caused by careless operation of the staff. This kind of behavior not only causes the equipment not to run normally, but also may lead to short circuit of the line in serious cases. Therefore, the requirements for preventing misinsertion are very high. According to Mr. Yuan of junao connector, there are two aspects to prevent misinsertion of wire to wire connectors, which are as follows: On the one hand, the misinsertion of line-to-line connector is a kind of error behavior caused by carelessness in the operation process. This behavior will not only cause the normal operation of the equipment, but also lead to the short circuit of the line in serious cases. Therefore, the requirements for preventing the wrong insertion are very high. According to Mr. Yuan of junao connector, there are two aspects to prevent misinsertion of wire to wire connectors, which are as follows:

On the one hand, for the wire-to-wire connector itself, if the dislocation error will lead to the wrong signal connection, then we need to pay attention to the selection of the wire-to-wire connector to prevent the wrong insertion as far as possible, so as to avoid this kind of error, and at the same time, it can also avoid damage to the device. It can also be configured and unique by adjusting the relative position in the wire-to-wire connector 。 The use of line-to-line connector can avoid this situation to a certain extent. Therefore, it is suggested that in order to reduce the types of materials or save costs, manufacturers must choose reliable and safe wire to wire connector products in the use process, so as to make their own equipment get good protection.

On the other hand, when the manufacturer uses the same connector, it is likely to check plug a to socket B. this situation requires special attention, because once this happens, the consequences will be very serious, and the AB interface must be connected to different sockets. For the anti misplug effect of line to wire connector, although it can not be completely solved now, with the development of science and technology and the update of products, I believe there will be a better solution in the future.