Bull horn connector is a very simple internal wiring device to use. The characteristic of a cow horn connector is that its structural structure on both sides resembles the two corners of a cow. Therefore, it is called a horn connector. On the other hand, the Jianniu connector is a cow horn connector without a buckle structure.
According to the requirements, the commonly used pin spacing for horn connectors comes in three specifications: 1.27 spacing, 2.0 spacing, and 2.54 spacing; The diameter of the square needle used can also be changed according to the spacing.
The application of horn connectors in the field of electronics is very extensive. Therefore, most equipment assembly personnel will face the problem of how to install the horn connector. Actually, we only need to grasp three points.
01. Insertion direction
When the horn connector is fully inserted to U=14.2, it should ensure that it reaches the specified 79483MD.
02. Vertical to the insertion direction
If the printed board or fixed board mounted connector is floating installed, the design of the free and fixed board mounted connectors should provide a displacement that can be adjusted by at least 1mm (note: for rigid installation of fixed board mounted connectors, the installation rack must have strict tolerances)
03. Tilt angle
The design of free and fixed board mounted connectors allows for tilt errors, with a longitudinal axis of ± 4 ° and a transverse axis of ± 4 °.
WeChat Scan
WeChat Scan
