Misinsertion is a kind of wrong behavior caused by careless staff during operation. This behavior will not only lead to the failure of normal operation of the equipment, but also lead to short circuit of the line in serious cases. Therefore, the requirements for preventing misinsertion are very high. According to Mr. Yuan of junao connector, there are two aspects to prevent the misinsertion of line-to-line connector, which are as follows: on the one hand, the misinsertion of line-to-line connector is a kind of wrong behavior caused by carelessness during operation. This behavior will not only lead to the failure of normal operation of the equipment, but also lead to short circuit in serious cases, Therefore, the requirements for anti misinsertion are very high. According to Mr. Yuan of junao connector, the misinsertion prevention of line-to-line connector has two aspects, as follows:
On the one hand, for the wire-to-wire connector itself, rotate 180 degrees. If the dislocation error will lead to the error of signal connection, it is necessary to select the wire-to-wire connector to prevent misinsertion as much as possible, so as to avoid this error and avoid damage to the device, You can also make the configuration unique by adjusting the relative position in the wire to wire connector. The use of wire-to-wire connector can avoid this situation to a certain extent. Therefore, it is suggested that in order to reduce the types of materials or save costs, manufacturers must choose reliable and safe wire-to-wire connector products in the process of use, so that their equipment can be well protected.
On the other hand, when the manufacturer uses the same connector, it is likely to check plug a to socket B. this situation needs special attention, because once this situation occurs, the consequences will be very serious, and the AB interface must be connected to different sockets. Although the anti misinsertion effect of wire to wire connector can not be completely solved now, with the development of science and technology and the renewal of products, it is believed that there will be a better solution in the future.